Table of Contents
Advertisement
ENGLISH
Troubleshooting
Troubleshooting
✤ Before contacting a Samsung authorized service centre,
perform the following simple checks.
They may save you the time and expense of an unnecessary call.
Self Diagnosis Display
Display
Informs that...
Blinking
the battery pack is almost discharged. Change to a charged one.
slow
When the remaining time on the tape
slow
TAPE END!
is about 2 minutes
no
TAPE END!
the tape reached its end.
there is no tape in camcorder.
TAPE!
slow
slow
the tape is protected from recording.
PROTECTION!
slow
the camcorder has some mechanical
.... D
fault.
L
C
R
moisture condensation has formed in
slow
the camcorder.
Moisture Condensation
✤ If the camcorder is brought directly from a cold place to a warm
place, moisture may condense inside the camcorder,
on the surface of the tape, or on the lens. In this condition, the
tape may stick to the head drum and be damaged or the unit
may not operate correctly.
To prevent possible damage under these circumstances, the
camcorder is fitted with a moisture sensor.
✤ If there is moisture inside the camcorder,
displayed. If this happens, none of the functions except
cassette ejection will work.
Open the cassette compartment and remove the battery.
Leave the camcorder for at least two hours in a dry warm
104
104
room.
✤
Action
Prepare a new one.
Change to a new one.
Insert a tape.
If you want to record, release
the protection.
1. Eject the tape.
2. Set to OFF.
3. Detach the battery.
4. Reattach the battery.
* If unresolved contact your
local service representative.
see below.
(DEW) is
✤
✤
CZECH
Advertisement
Table of Contents
