AEMC 1227 Quick Start Manual page 5

In addition to setting the instrument's clock, other basic setup tasks include:

Enabling Bluetooth (can be done on the instrument or via DataView)

Setting measurement units to °F or °C (can be done on the instrument or via
DataView)

Changing the Auto OFF interval (requires DataView)
Detailed information for configuring the instrument via the DataView Data Logger Control
Panel is available by pressing the Help button.
Enabling Bluetooth
Long press (>2 seconds) the
Selecting Temperature Units
Press to toggle between °C and °F.
Making Measurements
Air Speed:
1. Connect the sensor to the instrument.
2. If the instrument is OFF, press and hold down the
3. Press and hold down the
press the
appears on the LCD.
4. While continuing to hold down
units of measure. Options are M/S (meters per second), F/M (feet per minute),
KM/H (kilometers per hour), and M/H (miles per hour). When the desired
measurement is displayed, release
5. To change temperature units, short-press
6. Hold the sensor in the air flow. The arrow on the inside of the propeller must
point in the direction of the flow. This ensures the temperature sensor faces the
incoming air, allowing it to display an accurate value more quickly.
7. The air speed and temperature measurements are displayed on the LCD. (Wait
for the measurements to stabilize before accepting the reading.)
INSTRUMENT CONFIGURATION
button to enable/disable Bluetooth.
OPERATION
button to cycle through the measurement options until VELOC
button. While holding this button down, short-
, short-press
.
4
button until it turns ON.
to select the air speed
.