Troubleshooting; Other Features; Your Clock Radio; Get Started - Philips AJ3115 User Manual

EN
1 Important
•
Read these instructions.
•
Heed all warnings.
•
Follow all instructions.
•
Do not block any ventilation openings. Install in accordance with
the manufacturer's instructions.
•
Do not install near any heat sources such as radiators, heat
registers, stoves, or other apparatus (including amplifiers) that
produce heat.
•
Protect the power cord from being walked on or pinched,
particularly at plugs, convenience receptacles, and the point
where they exit from the clock radio.
•
Only use attachments/accessories specified by the manufacturer.
•
Unplug this clock radio during lightning storms or when unused
for long periods of time.
•
Refer all servicing to qualified service personnel. Servicing is
required when the clock radio has been damaged in any way,
such as power-supply cord or plug is damaged, liquid has been
spilled or objects have fallen into the clock radio, the clock
radio has been exposed to rain or moisture, does not operate
normally, or has been dropped.
•
Battery usage CAUTION – To prevent battery leakage which may
result in bodily injury, property damage, or damage to the clock
radio:
•
Install the battery correctly, + and - as marked on the clock
radio.
•
Remove the battery when the clock radio is not used for a
long time.
•
The battery shall not be exposed to excessive heat such as
sunshine, fire or the like.
•
This clock radio shall not be exposed to dripping or splashing.
•
Do not place any sources of danger on the clock radio (e.g.
liquid filled objects, lighted candles).
•
Where the plug of the Direct Plug-in Adapter is used as the
disconnect device, the disconnect device shall remain readily
operable.

2 Your clock radio

Congratulations on your purchase, and welcome to Philips! To fully
benefit from the support that Philips offers, register your product at
www.philips.com/support.
What's in the box (Fig. )

3 Get started

Always follow the instructions in this chapter in sequence.
Install battery
You can only use AC power as power supply. The battery can only
back up clock and alarm settings.
Caution
•
Risk of explosion! Keep the battery away from heat, sunshine or fire.
Never discard battery in fire.
•
The battery contains chemical substances, so it should be disposed of
properly.
Insert 2 AAA batteries (not supplied) with correct polarity (+/-).
(Fig. )
Tip
•
The display backlight is off when AC power is disconnected.
Connect power (Fig. )
Caution
•
Risk of product damage! Make sure that the power voltage
corresponds to the voltage printed on the back or underside of
the clock radio.
•
Risk of electric shock! When you unplug the power adapter, always
pull the plug from the socket. Never pull the cord.
Note
•
The type plate is located at the bottom of the clock radio.
Set time (Fig. )
Note
•
You can only set time in standby mode.

4 Listen to FM radio

Note
•
Keep the clock radio away from other electronic devices to avoid
radio interference.
•
For better reception, fully extend and adjust the position of the
FM antenna.
Tune to FM radio stations (Fig. )
Store FM radio stations manually
You can store up to 10 FM radio stations.
1 Tune to an FM radio station.
2 Press and hold PRESET for two seconds.
» The preset number begins to blink.
3 Press TUNING repeatedly to select a number.
4 Press PRESET again to confirm.
5 Repeat steps 1 to 4 to store other stations.
Tip
•
To remove a pre-stored station, store another station in its place.
Select a preset radio station
In tuner mode, press PRESET repeatedly to select a preset number.
Adjust volume
While listening, press - VOLUME + to adjust volume.

5 Other features

Set alarm timer
You can set two alarms to ring at different time.
Set alarm
Note
•
You can only set the alarm in standby mode.
•
Make sure that you have set the clock correctly.
Follow the illustration to set the first alarm. (Fig.
•
AL1: set the first alarm.
•
AL2: set the second alarm.
Tip
•
The clock radio exits alarm setting mode when being idle for 10
seconds.
Select alarm source
You can select FM radio or buzzer as the alarm source. (Fig.
» The corresponding alarm icon lights up.
Note
•
If FM radio is selected as alarm source, when alarm sounds,
volume rises gradually. You cannot adjust the alarm volume
manually.
•
If Buzzer is selected as alarm source, the alarm volume will be at
default level and cannot be adjusted.
Activate/deactivate the alarm timer
Press AL1 or AL2 repeatedly to activate or deactivate the alarm
timer. (Fig. )
» If the alarm timer is deactivated, the alarm indicator turns off.
» The alarm repeats ringing for the next day.
Snooze the alarm
When alarm sounds, press SNOOZE.
» The alarm snoozes and repeats ringing nine minutes later.
Set sleep timer
This clock radio can switch to standby mode automatically after a
preset period. (Fig. )
To deactivate the sleep timer:
•
Press SLEEP repeatedly until [OFF] (off) appears.

6 Product information

Note
•
Product information is subject to change without prior notice.
Specifications
Amplifier
Total Output Power 200 MW RMS
Tuner (FM)
Tuning range 87.5-108 MHz
Tuning grid 50 KHz
Sensitivity
- Mono, 26 dB S/N Ratio <22 dBf
- Stereo, 46 dB S/N Ratio <51.5 dBf
Total Harmonic Distortion <3%
Signal to Noise Ratio
General information
AC power (power adapter)
Operation Power Consumption
Standby Power Consumption
Dimensions:
Main Unit (W x H x D)
Weight:
-Main Unit
-With Packing

7 Troubleshooting

Warning
•
Never remove the casing of this apparatus.
To keep the warranty valid, never try to repair the system yourself.
If you encounter problems when using this apparatus, check the
following points before requesting service. If the problem remains
unsolved, go to the Philips web site (www.philips.com/support).
When you contact Philips, ensure that the apparatus is nearby and
the model number and serial number are available.
No power
• Ensure that the AC power adaptor of the unit is connected
properly.
• Ensure that there is power at the AC outlet.
No sound
• Adjust the volume.
)
No response from the unit
• Disconnect and reconnect the AC power plug, then turn on the
unit again.
Poor radio reception
• Increase the distance between the unit and your TV or other
radiation sources.
• Fully extend the FM antenna.
Alarm does not work
• Set the clock/alarm correctly.
Clock/alarm setting erased
)
• Power has been interrupted or the power plug has been
disconnected.
• Reset the clock/alarm.
8 Notice
Any changes or modifications made to this device that are not
expressly approved by Gibson Innovations may void the user's
authority to operate the equipment.
Disposal of your old product and batteries
Your product is designed and manufactured with high quality
materials and components, which can be recycled and reused.
Never dispose of your product with other household waste. Please
inform yourself about the local rules on the separate collection of
electrical and electronic products and batteries. The correct disposal
of these products helps prevent potentially negative consequences
on the environment and human health.
Your product contains batteries, which cannot be disposed of with
normal household waste.
Please inform yourself about the local rules on separate collection
of batteries. The correct disposal of batteries helps prevent
potentially negative consequences on the environment and human
health.
Please visit www.recycle.philips.com for additional information on a
recycling center in your area.
Environmental information
All unnecessary packaging has been omitted. We have tried to make
the packaging easy to separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene (bags, protective foam
sheet.)
Your system consists of materials which can be recycled and reused
if disassembled by a specialized company. Please observe the local
regulations regarding the disposal of packaging materials, exhausted
batteries and old equipment.
>50 dBA
Brand name: Philips;
Model: AS030-050-EM050;
Input: 100-240 V~, 50/60 Hz;
0.15 A;
Output: 5 V 0.5 A
5 W
<1 W
130 x 46 x 130 mm
0.26 kg
0.4 kg