Advertisement
WARNING
!
• Study, understand, and follow all instructions
provided with and on this device before use.
• Rated capacity is PER PAIR! DO NOT exceed
rated capacity.
• Use as a matched pair to support one end of a
vehicle only. Use only ONE (1) PAIR per vehicle.
• Use only on hard, level surface. Properly secure
vehicle before using jack stands.
• Center load on ratchet bar saddle.
• Jack stands are not to be used to simultaneously
support both ends or one side of a vehicle.
• No alterations shall be made to this device.
• Failure to heed these markings may result in
personal injury and/or property damage.
PREPARATION
1. Verify the product and your application are compatible.
2. Read this manual completely, examine the jack
stands and familiarize yourself with the components.
Recognize the hazards associated with its improper
use before using the product.
3. Refer to the vehicle owner's or service manual for
location of proper lift and support points.
4. Remove the Ratchet Bar Locking Pin to release the
Ratchet Bar. The purpose of the Locking Pin is to
avoid inadvertent removal of the Ratchet Bar from the
collar. Reinstall the Locking Pin when transporting
the jack stands.
OPERATION
Supporting Load
!
WARNING: Use only to support areas of the
vehicle as specified by the vehicle manufacturer.
Use only on vehicles whose support points are compatible
with the saddle of the jack stand. Incompatibility or
improper placement may result in structural damage
to the vehicle and/or jack stand. Structural damage to
either may result in sudden and unexpected loss of load
height!
!
WARNING: Do not use attachments and/or
adapters with this product.
1. Inspect your stands before each use. If any part is
missing or damaged, do not attempt to use the jack
stands and Contact Omega Technical Service.
2. Raise the locking handle and manually adjust the
ratchet bar to allow placement under vehicle.
3. After raising vehicle, carefully position the jack
stands so that the load will be centered on the
ratchet bar saddle. Raise the locking handle until
the ratchet bar saddle engages the load. Jack
stands should be at same height.
4. The Locking Handles on your Omega MagicLift™Jack
Stands are spring loaded to help secure the Ratchet
Bar in desired position. After adjusting the jack
stand, release the Locking Handle and pull down on
the Ratchet Bar to confirm the pawl and ratchet are
engaged. The bar should maintain height.
5. Slowly lower the vehicle onto the stands while
monitoring load distribution and jack stand height.
6. Verify the vehicle is secure before working on,
around or under.
Lowering load
!
WARNING: Be sure that all tools and personnel
are clear before lowering load.
1. Using a suitable jack, raise vehicle clear of stands.
2. Carefully remove jack stands, and lower vehicle
with lift device.
MAINTENANCE
Periodically inspect each stand. Ensure all parts move
freely. Do not apply oil or grease to any portion of this
product. Do not allow dirt to accumulate on Air Spring.
If rust appears, sand affected area and cover with a
suitable utility paint.
Storage
Store stands in upright position and in a clean, dry
area.
REPLACEMENT PARTS
Not all components of the jack are replacement items,
but are illustrated as a convenient reference of location
and position in the assembly sequence. When ordering
parts, please give the Model number, part number and
parts description.
3
Advertisement
