RC-5
Quick Start Guide
Software download: www.elitechlog.com/softwares
Install Battery
1.Use a proper tool (such as a coin) to loosen the
battery cover.
2.Install the battery with "+" side upward and keep
it under the metal connector.
3.Put the cover back and tighten the cover.
Note: Do not remove the battery when the logger
is running. Please change it when necessary.
1
Install Software
1.Please visit www.elitechlog.com/softwares. Select
and download the software.
2.Double click to open the zip file. Follow the
prompts to install it.
3.When the installation is completed, the ElitechLog
software will be ready to use.
Please disable the firewall or close the antivirus
software if necessary.
Start/Stop Logger
1.Connect the logger to a computer to sync the
logger time or configure parameters as needed.
2. Press and hold
to start the logger until
shows. The logger starts logging.
3.Press and release
to shift between display
interfaces.
4.Press and hold
to stop the logger until
shows. The logger stops logging.
Please note all the recorded data cannot be
changed for security reasons.
2
Important !
Please store the logger in indoor environment.
◆
Do not use the logger in corrosive liquid or excessive
◆
heat environment.
If this is the first time you use the logger , it is
◆
suggested to connect the logger to a computer
to sync the time.
Please dispose or handle the waste logger
◆
properly by local legislation.
Elitech Technology, lnc.
www.elitechlog.com
1551 McCarthy Blvd, Suite 112
Milpitas, CA 95035 USA
V2.0