Wired Remote Controller-Buttons and Display
The wired remote controller is an optional accessory and it is installed on the wall.
To use the wired remote controller, refer to an appropriate manual.
Communication error indicator
On Timer setting
Off Timer setting
On Timer button
Off Timer button
Removing frost indicator
(Except Cooling Only Models)
- Test button is for your installation specialist. You must NOT press it.
- After cleaning the air filter, press the filter reset button. Then the wired remote
controller will display the FILTER SIGN indicator when the time to clean the air filter;
refer to page 12.
- Duct type air conditioner does not have function of adjusting air flow direction.
Therefore, the function is not operated even if you press the swing button.
- The heating mode( ) is not selected in cooling only models.
Centralized controller indicator
(In case of installing the Centralized controller)
Mode selection button
Air flow direction
Filter Sign indicator
On/Off & Timer
Fan speed adjustment
Filter Reset button