Black Box RS-VIEWER User Manual page 12

CHAPTER 3: BASIC CONFIGURATION OF THE RS-VIEWER
By checking the box "Use DHCP to obtain DNS server address," you enable automatic setting of DNS server addresses through
DHCP. If you do not enable the automatic assignment of DNS server addresses, you need to set them in the bars "Primary DNS
server" or "Secondary DNS server."
You can also enter the IP address, the subnet mask, the default gateway as well as the primary and secondary server DNS of your
network.
If the assignment of IP address through DHCP is enabled, the entered setting of the IP address, mask etc. is taken as the alternate
configuration, i.e. configuration used in case the DHCP server is not available. If you are not using DHCP to assign the IP address,
all items (IP address, subnet mask, default gateway and the primary and secondary DNS servers) have to be set for your network.
To save changes, press the "Apply" button.
In changing the IP settings, you need to reset the RS-VIEWER unit. Confirm the changes in the setup by clicking "Yes" on the next
page. This will also initiate the reset.
12
FIGURE 3-9. CHANGE IP SETTINGS SCREEN
FIGURE 3-10. RESET THE UNIT
1.877.877.2269 BLACKBOX.COM
NEED HELP?
LEAVE THE TECH TO US
LIVE 24/7
TECHNICAL
SUPPORT
1.877.877.2269