Mira Miniduo Installation And User Manual page 11

9. For Rear Entry Supplies Only:
a) Fit the concealing plates over the inlet
pipes.
Note! Apply silicone sealant to the back
face of the flange.
Apply Silicone Sealant
10. Caution! It is essential at this point
that the supply pipework is thoroughly
flushed through before connection to the
mixer. Failure to do so may result in product
malfunction and will not be covered under the
guarantee.
11. Fit the compression nuts and olives onto the
pipework.
12. Align the mixer with the pipework and fit onto
the backplate.
Important! Make sure that the hot and cold
inlets on the mixer correspond with the hot and
cold inlet supplies.
13. Tighten the compression nuts onto the mixer
with a suitable wrench.
Caution! Take care not to damage the chrome
surfaces.
14. Tighten the grubscrews to secure the mixer to
the backplate.
Concealing Plate
15. Fit the shower fittings, refer to your shower
fittings installation and user guide for
instructions.
Important! For high pressure systems (above
0.5 bar) make sure that the flow regulator
(supplied) is fitted, refer to section: 'Flow
Regulators'.
16. Turn on the hot and cold water supplies and
check for leaks.
17. Before using the shower, refer to section:
'Commissioning'.
Adjustable Elbow Installation
1. Unscrew the elbow grubscrews on the
thermostatic mixer with a 2.5 mm hexagonal
key (supplied with the thermostatic mixer), pull
off the inlet elbows and discard.
2. Using the 'O' key (supplied with the thermostatic
mixer) or a 12 mm hexagonal key, unscrew the
inlet nipples and discard.
3. Fit the new adjustable elbow inlet nipples and
tighten with the 'O' key.
4. Make sure that the 'O' seal is fitted and
push the new elbow fully onto the inlet
nipple. Tighten the grubscrew with a 2.5 mm
hexagonal key.
5. Remove the backplate from the mixer by
removing the grubscrew with a 2.5 mm
hexagonal key.
6. Draw a centre line between the inlet pipework
and, using the adjustable backplate as a
template, mark the position of the adjustable
backplate fixing holes.
7. For solid walls drill the holes for the backplate
with a 6 mm drill and insert the wall plugs
(supplied). For other types of wall structure
alternative fixings may be required (not
supplied).
8. Secure the backplate to the wall using the
screws (supplied).
9. Align the mixer with the pipework and fit onto
the backplate.
Note! Make sure that the pipes are pushed
fully into the inlet connectors.
10. Tighten the compression nuts onto the mixer
with a suitable wrench.
Caution! Take care not to damage the chrome
surfaces.
11. Tighten the adjustable backplate grubscrews
with a 2 mm hexagonal key (supplied) to
secure the mixer to the backplate.
11 1082138-W2-P