Mira Miniduo Installation And User Manual page 10

3. For solid walls drill the holes for the backplate
with a 6 mm drill and insert the wall plugs
(supplied). For other types of wall structure
alternative fixings may be required (not
supplied).
6 mm Drill
4. For Rear Entry Supplies Only:
a) Drill the holes for the supply pipes at
110 mm centres.
Note! Recess the inlet holes Ø19 mm x
2 mm deep to allow for the concealing
plates.
5. Fit the supply pipework: Hot - Left, Cold
- Right. The inlet pipework should extend
23 mm from the finished wall surface.
Note! If it is not possible to install the mixer with
this pipework configuration follow instruction 6.
Elbow
HOT
Recess Ø19 mm
x 2 mm deep
6. Reversed Inlet Supplies Only:
1082138-W2-P
Wall Plug
23 mm from finished
wall surface
COLD
23 mm
110 mm
a) Using a suitable tool, carefully remove the
plug cap from the centre of sealing plug
to reveal keyway.
b) Remove the sealing plug using the 'O' key
(supplied) or a 12 mm hexagonal key.
c) Unscrew the outlet nipple using the
'O' key (supplied) or a 12 mm hexagonal
key.
Note! On Mira Minilite Eco models
carefully remove the flow regulator from
the outlet nipple first.
d)
Refit the sealing plug and outlet nipple in
the opposite outlets and tighten.
Note! Make sure that the 'O' seals are
correctly fitted.
Note! On Mira Minilite Eco models refit
the flow regulator.
e)
Rotate the mixer 180°.
f)
The control knob(s) will have to be
realigned, this can be completed in
section: 'Commissioning'.
Plug Cap
Sealing Plug
'O' Seal
7. Remove the backplate from the mixer by
loosening the grubscrews with a 2.5 mm
hexagonal key (supplied).
8. Secure the backplate to the wall using the
screws (supplied).
10
Backplate
Screw