Using The Shark Ion Robot; Buttons And Indicator Lights; Using The Shark Ion Robot Remote; Setting The Day And Time - Shark ION RV700_N series Owner's Manual

USING THE SHARK ION™ ROBOT

BUTTONS AND INDICATOR LIGHTS

Clean
Dock Max
s h a r kc l e a n . c o m
CLEAN BUTTON
Press to begin a long-running
cleaning session. Press again
to stop.
Clean
Dock Max
DOCK BUTTON
Press to stop cleaning and
send robot back to the
charging dock.
Clean
Dock Max
MAX MODE BUTTON
Press to begin a powerful
cleaning.
Clean
Dock Max
CHARGE INDICATOR LIGHTS
Display the amount of charge
remaining in the battery.
Clean
Dock Max
"!" ERROR INDICATOR
When illuminated, clear
any blockages, empty dust
bin, and clean filters. See
Clean Troubleshooting section for
full list of error codes.
Dock Max
SCHEDULE INDICATOR
Illuminates when a cleaning
time is actively scheduled.
Clean
Dock Max
USING THE SHARK ION™ ROBOT

USING THE SHARK ION ROBOT REMOTE

The remote control requires 2 AAA batteries. Install batteries into remote before using.
With the remote control, you can start and stop Shark ION Robot, select Spot
Cleaning mode, send the unit back to the charging dock, and program a cleaning
schedule for your robot.
Dock Max
Clean
Enter
Hold / to Set
1 Signal Icon
2 Time Icon
1
3 Schedule Icon
4 Days Of The Week (Mon–Sun)
2 3
5 Scheduling (On/Off)
4
6 Time
5 6
A Dock Button
B Max Mode Button
C Navigation Arrows
A B
Dock Max
D Clean/Enter Button
E Time Button
F Schedule Button
Clean
C D
Enter
E F
Hold / to Set

SETTING THE DAY AND TIME

1 Press and hold the TIME button (with the clock
2 Press the UP/DOWN navigation arrows on the
3 Use the UP/DOWN arrows on the remote control
Dock Max
4 Use the UP/DOWN arrows to select the minutes,
Clean
Enter
5 Use the UP/DOWN arrows to select AM or PM,
6 Once you have finished setting the time, you can
Hold / to Set
icon) on the remote for one second. On the screen,
the day of the week display will begin flashing.
remote control to select the day of the week,
then press the CLEAN/ENTER button to set. On
the screen, the hour field in the time display will
begin flashing.
to select the hours, then press the CLEAN/
ENTER button to set. On the screen, the minutes
field in the time display will begin flashing.
then press the CLEAN/ENTER button to set. On
the screen, AM and PM will begin to flash.
then press the CLEAN/ENTER button to set.
proceed to setting a cleaning schedule.
s h a r kc l e a n . c o m