Download Print this page

Epson PS-100 Series Quick Start Manual page 2

Hide thumbs

Advertisement

3.
Unfasten the buckle of the wristband as shown below.
4.
Insert the band fastener into the hole number you checked in step 2.
Band fastener
5.
Put your hand through the wristband and fasten the buckle. When wearing the
product, make sure it does not touch the ulna bone. Move the band fastener to
a smaller hole number if the wristband is loose.
Ulna
3. Using PS-100 Series for the First Time
Charge the product as shown below when using it for the first time. The product turns
on when charged. Make sure that charging is complete.
1.
Attach the charging cradle to the product.
A Align the EPSON logos on the product and charging cradle and tilt the product as
shown.
B Insert the protruding latch on the charging cradle into the hole on the side of the
product.
Hole
2.
Connect the USB connector.
f Using a PC
Connect the charging cradle's USB cable to the USB port on the PC.
Note that some PCs may not be supported. Try connecting the charging cradle and
the PC directly without using a USB hub.
f Using an AC adaptor
Connect the charging cradle's USB cable to the AC adaptor, and then connect
the AC adaptor to the power socket.
We recommend using the specified AC adaptor (XXXX optional.) Charging may not
be possible or the product may not operate if any other AC adaptor is used.
When connection is established, the LED light on the product turns on.
• The LED is orange while charging and blue
when charge is complete.
• Charging takes approximately TBD (1.5 to
2.5?) hours to complete; however, the
duration varies depending on the condition.
Hole number
Insert the band fastener into
the wristband adjustment
hole
Sensor
(reads your pulse on the back of your wrist)
Protruding
latch
Blue
Orange
3.
Detach the charging cradle from the product when charge is complete.
Detach them by opening the part indicated with
from the other side.
4. Initial Configuration
You need to perform initial configuration before using PS-100 Series for the first time.
You can use a smartphone to perform the initial configuration.
Supported devices and operating systems
Check the following website.
http://
Perform initial configuration such as creating the account and pairing using a
smartphone.
1.
Search your smartphone's application store for Epson PULSENSE View, and
then install it.
2.
Start Epson PULSENSE View.
Make sure that the product is within one meter from the smartphone.
3.
Follow the instructions in the Epson PULSENSE View guide.
5. Contact Us
6. Service and Repair
outwards and push the product

Advertisement

loading

  Also See for Epson PS-100 Series

  Related Manuals for Epson PS-100 Series