Panasonic KW9M User Manual page 129

Reset integral power
It reset all integral power.
For reset integral power, workers code should be designated, but it doesn't record and the code is
fixed to '0'. It is available only with pressing <MODE> key (programming key).
・Command from master; control code 1AH
68H A0 A1
Transmission address
⇒
continue
・Response from slave (normal)
68H A0 A1
Abnormal command from slave
Control code (C); C0H (Response from slave is abnormal.)
68H A0 A1
Conditions for no response
With the below conditions, slave doesn't response.
・Parity error
・CS error
・Data length (L) doesn't match byte count.
・Error at write or read of transmission address
・Not press programming key (<MODE> key)
Programming key
Programming key is <MODE> key.
With every display, it is possible to change the settings only when pressing <MODE> key.
Phone: 800.894.0412 - Fax: 888.723.4773 - Web: www.clrwtr.com - Email: info@clrwtr.com
A2 A3 A4 A5
PA
Authorization level (33H fix)
continue
A2 A3 A4
+ Control code when error occurs.
A2 A3 A4 A5
Bit flag
Contents of
error code
68H 1AH
Control code
P0
Password (P2: 33H fix)
C0 C1
⇒
Workers code (33H fix)
A5 68H 9AH
68H C
Control code
Bit 7 Not support
Bit 6 Not support
Bit 5 Not support
Bit 4 Not support
Bit 3 Impossible to change transmission speed
Bit 2 Password mistake
Bit 1 No request data
Bit 0 Other errors
125
08H
⇒
continue
P1 P2
continue
C2 C3 CS
00H CS 16H
01H ERR
Error code
(bit flag)
Contents
⇒
16H
16H