Table of Contents
Advertisement
For additional protection, thermal cut-off device which is activated at 158°F / 70°C. Under normal operation, it will
take 45-50 minutes for the motor to reach 158°F / 70°C at open flow condition. Once the power is cut off to the
unit, it takes 15-20 mintues to reset. Power is restored after motor temperature has dropped to 131°F / 55°C.
Wall Power
Transformer
Before the Bottled Water Dispensing System is put into service, the system should be sanitized by following the
maintenance and sanitation clean in-place procedure on page five (5).
After the Bottled Water Dispensing System has been mounted in a suitable location with the suction wand installed
into the bottle and the discharge tube routed to the appliance water inlet (or to the optional drinking water faucet),
the 115 volt AC and 230 volt AC systems must be plugged into a grounded outlet, and the 12 volt DC system must
be hard wired to the vehicle or boat electrical system as outlined in the electrical section.
Turn the dispensing system on by placing the on/off switch in the on position (light will turn on) and operating the
appliance dispensing valve or the drinking water faucet to vent all the air from the Bottled Water Dispensing System.
After air is evacuated from the system, close the appliance dispensing valve or the water faucet and the pump will
stop automatically until you open the water dispenser valve or water faucet. Follow manufacturer's plumbing and
operating instructions with commercial coffee and tea brewers.
For refrigerators with icemaker only, the seal at the icemaker connection should be loosened or disconnected to vent
the trapped air in the system. When water is present at the connection, reconnect, tighten and check for leaks.
Once the system is vented, it will not require venting again even after bottle changes.
SUCTION WAND INSTALLATION
To install the suction wand into standard 5 gallon bottle,
place bottle close to system and remove bottle cap, then
install suction wand into bottle. (Note: If bottle is over
filled, dispense enough water to allow the suction wand
to be installed to the bottom of the bottle). Push suction
wand bottle cap over bottle and push wand to bottom
center of bottle.
SUCTION WAND REMOVAL AND
CHANGING BOTTLES
Before removing suction wand from empty bottle, move
bottle to an open area outside of cabinet. Put new bottle
next to empty bottle, clean neck and cap area with
detergent, and remove cap. Remove suction wand from
empty bottle by lifting wand cap with a rocking motion
and pull cap off bottle, sliding suction wand out of the
bottle and place directly into new bottle while sliding cap
over new bottle neck.
TEMPERATURE WARNING
Grounded Outlet
Power
Cord
SYSTEM START-UP
Do not attempt to remove suction wand by pulling
on the soft plastic tube, which can result in
permanent breakage of suction wand.
Do not place suction wand on floor, counter, or sink as
this could contaminate the suction wand assembly. If
bottle is over filled, dispense enough water to allow the
suction wand to be pushed to bottom of bottle.
WARNING!
Damaged power cord must be
replaced by factory authorized
service only!
7
Hide quick links:
Advertisement
Table of Contents
