How The System Works; Inventory Of System Components; Tools Required To Install System - FLOJET Bottled Water Dispenser Plus Installation & Maintenance Instructions Manual

The FLOJET Bottled Water Dispensing System was designed to pump purified water from a commercially available
5-gallon purified water bottle. The system will deliver the water under pressure to an individual drinking water faucet,
the water inlet of a refrigerator for the icemaker and chilled drinking water tap, and to certain commercial coffee / tea
brewers.
When the suction wand is inserted into the standard 5-gallon bottle, it will activate the float switch on the end of the
wand and turn on the pump. This same float switch shuts off the system when the bottle is empty. The wand has a
built in back-flow preventor valve that prevents water in the system from flowing back into the bottle, or spilling while
changing bottles.
The heart of the system is the pump module that automatically adjusts the flow and pressure to fill an appliance or
faucet, and stops automatically.
The system is equipped with an automatic thermal cut-off device for additional protection.
A. Pump Module with On/Off Rocker Switch, 3.5 ft. (1m) Cord.
B. Suction Wand and Hose Assembly
C. 20 ft (6.1m) of 1/4 in. (6.35mm) Discharge Tube
D. Kit Fitting: Hose port/connector,
compresion nut
and sleeve.
E. Wall power transformer.
1. Medium sized Wrench
2. 7/16 in. (11.12mm) or
1/2 in. (12.7mm) Drill Bit
3. Power Drill
4. Sharp Knife or Box Knife
2

HOW THE SYSTEM WORKS

INVENTORY OF SYSTEM COMPONENTS

A

TOOLS REQUIRED TO INSTALL SYSTEM

1
B C
2 3
D E
4