Replenishing Supplies; Syrup; Type 1 Bib Syrup Connections - Cornelius Viper Elite Operator's Manual

Operator's Manual
S
YRUP
If the system indicates that the syrup is sold out, the procedure in Table 5. should be performed to replace the BIB
(Bag-In-Box) syrup source.
Step
1.
2.
3.
T 1 BIB S C
YPE YRUP
Refer to Table 6. and Figure 7. when replacing a Type 1 BIB container.
Step
1.
2.
3.
4.
5.
Publication Number: 621360241LOEWOP

REPLENISHING SUPPLIES

Replace the empty BIB and wait for the Out of Product indicator light go off.
Fill the barrel by pulling to open up the barrel faceplate relief valve for the bar-
rel (See Figure 6.). The product will then begin to fill inside the barrel, Con-
tinue filling the barrel to the scribe line on the faceplate, as shown in Figure 6.
When the barrel is full, turn on refrigeration. When refrigeration shuts off, the
product is ready to serve.
FUB Product Level
FCB Product Level
Relief Valve
ONNECTIONS
Unscrew unit connector from the empty syrup box.
Place a new BIB on the rack, with the proper side up, and open the cardboard
flap. Be careful not to puncture the bag with any sharp objects.
Pull the bag container out of the box and remove the dust cap.
Rinse the connector in warm water.
Screw the connector (clockwise) onto the bag connector.
!
IMPORTANT:
The connection MUST be air tight.
Table 5.
Procedure
Figure 6.
Table 6.
Procedure
- 8 - © 2015-2017, Cornelius Inc.