Table of Contents
Advertisement
2.5 Device parameters
2.5.1 Network parameters
Go into <Device parameters>→<Network parameters>.then you can setup network parameters.
As other IP device, connect and use IP camera, must let IP camera's IP address Full-Mesh as user PC's IP address. Please note that: In the same LAN, IP
address can not be the same, it will has clash, and let device can't work.
After modify IP address, click"SAVE" ,it will display"Now modify the network address, the page will automatically jump in 5 seconds!If there is no successful
jump please manually modify."
IP camera is a kind of IP device, before use, need rational allocation IP address,gateway..etc.information. We had already configuration default IP
information, this value can be change if you need.
The device IP address192.168 .1.8
Netmask:255.255.225 .0
Gateway：192.168.1.1
Data port：6002
2.5.2 Protocol setup
Onvif protocol default open, Device ID is 28181 server assign to the camera's ID , Registered password is needed for the corresponding device ID
password， device is in 28181 domains,sever ID is 28181's server ID, server's IP is 28181's IP address, sever port is sever provide to outside's port NO. Alarm
device ID is when the camera catch alarm information, will according to this ID to send alarm information.
20
Advertisement
Table of Contents
