VeriFone Vx670 Installation Manual page 31

3
Remove the battery.
Figure 18
4
After removing the battery, the MSAM compartments are exposed.
5
Remove any previously installed MSAM card by sliding the card from the
MSAM cardholder.
6
Install an MSAM card by aligning the card and carefully sliding it within the
guides on the cover until it is fully inserted (see
holders are labeled MSAM1, MSAM2, and MSAM3.
Figure 19
Before inserting the MSAM card, position it as shown in
NOTE
gold contacts facing the smart card reader end of the terminal. The cardholder
connector base has a set of contacts and a notch on one corner to ensure the
MSAM card is positioned correctly. The MSAM card has a notch on one corner to
ensure that it fits into the connector base in only one way. The MSAM
compartment door will not close properly if the MSAM cards are installed
incorrectly.
7
Install the battery (see
Removing the Smart Battery
Installing MSAM Card
Figure 22).
T
ERMINAL
Installing/Replacing MSAM Cards
Figure 19). The MSAM card
Figure 19, with the card's
X
V 670 I
NSTALLATION
S
ETUP
31
G
UIDE