Caution for safety Any electrical installation work must be carried out by a qualified electrician or competent person. This electric appliance must be installed according to the instructions in order to avoid a damage. This oven should be disconnected from the power supply before installation or maintenance. This oven should always be earthed.
The work in the high cabinet Oven dimensions and kichen cabinet dimensions are shown in the fig-2A, 2B. A gap must be minimum 10mm between the rear of the installed oven and the connecting wall. To Lift oven, use side holes of the oven (refer to arrow, Fig-2A). Kitchen cabinet in contact with the oven must be heat resistant up to 90 °C, and close units fronts up to at least 70 °C.
For Ventilation For correct ventilation, the ventilation opening of 50mm should be required between the back wall and the floor of the installation cabinet (See “Q ” fig--1D, 2B & 3A), the ventilation gap of 5mm is required between the oven top rim and the cooktop lower rim, and between the oven both sides rim and the cabinet (fig-3B, 3C), these openings must not be closed by any way.