Connection Of Accessories (Rear Panel) - Kenwood TS-890S Instruction Manual

Connection of Accessories (Rear Panel)

A cable exceeding 3 m (9.8 feet) may not be connected
●
to a connector below.
• KEY jack
• ACC 2 connector
• REMOTE connector
• METER jack
• DRV connector
• KEYPAD jack
• COM connector
• EXT.SP jack
• DISPLAY connector
• LAN connector
• PHONES jack
• PADDLE jack
• MIC connector
Key for CW (KEY)
■
For CW operation without using the built-in electronic keyer,
connect the plug of an electronic key, bug key, external electronic
keyer or PC keyer to the KEY jack. Use a Φ3.5 mm two-pronged
plug. Positive keying needs to be used for external electronic
keyers and PC keyers. Use a shielded cable to connect the key
and this transceiver.
For more detailed explanation on the built-in keyer, refer
●
to "Electronic Keyer". (5-13)
Meter 1
7 9
3
COMP
ALC
44
（＋） （−） （＋）
Meter (Commercially
Available)
.
Straight Key (Commercially Available)
Paddle (Commercially Available)
Meter 2
7 9
3
COMP
ALC
52V 44 52V
vd vd
（−）
Add a resistor as necessary.
INSTALLATION AND CONNECTION 1
USB Flash Drive/USB Keyboard (
■
For connecting a commercially available USB flash drive or USB
keyboard.
Plug the USB flash drive or USB keyboard firmly into the
(USB-A) connector.
A USB flash drive or USB keyboard can be connected to
●
the connector on the front panel and rear panel
respectively.
Keypad (KEYPAD)
■
For connecting a self-made PF keypad.
External Speaker (EXT. SP 8Ω)
■
For connecting an external speaker.
The EXT. SP 8 Ω is used exclusively for connecting an
●
external speaker. Due to the loud audio output, hearing
may be impaired when headphones are used. Do not
connect headphones.
External Display (DISPLAY)
■
Connect this transceiver with an external display using a
commercially available DVI cable.
Doing so enables information displayed on the screen of this
transceiver to be shown on the external display.
Use an external display with a resolution of 800 x 600 or
●
848 x 480.
This transceiver supports digital and analog outputs.
●
If the display to connect uses a D-sub terminal, make use
●
of a commercially available DVI/D-Sub conversion
adapter.
External Meter (METER)
■
For connecting a commercially available meter.
USB Keyboard (Commercially Available) or
USB Flash Drive (Commercially Available)
Rear Panel
Φ3.5 mm
(E type)
Stereo
External Speaker (Optional or
Commercially Available)
External Display
(Commercially Available)
To DVI Port
DVI Cable
)
1-3