Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for Bierer DCI-50-CT
Summary of Contents for Bierer DCI-50-CT
- Page 1 Operating Instructions DCI-50-CT Cable Identifier...
- Page 2 Bierer & Associates Inc. Bierer & Associates Inc. does not express or imply to be an insurer of these risks, and by purchasing or using this product you AGREE TO ACCEPT THESE RISKS. IN NO EVENT SHALL Bierer &...
- Page 3 TRANSFORMER SWITCH LEAD DCI 50 GROUNDED DCI 50 FAR END BLACK MAN HOLE OR DITCH LEAD TRANSFORMER SWITCH LEAD DCI 50 GROUNDED DCI 50 FAR END BLACK MAN HOLE OR DITCH LEAD LEAD DCI 50 DCI 50 BLACK LEAD SIGNAL MOVING IN OPPOSITE DIRECTIONS Diagram 1...
- Page 4 Isolate section of cable to be tested at near end and ground on far end. Verify voltage is not present on cable being tested using an OSHA approved test device such as a Bierer voltage detector. . Install DCI50 as shown in Diagram 1.
- Page 5 IDENTIFY URD CABLE USING STRCV 1. Follow the “DC TRANSMITTER SET-UP AND TEST” Procedure outlined on page 4. 2. Ensure the power light is on, the blue pulse light is pulsing, and the green short continuity light is illuminated. If the red open light is on, turn the unit off, check your connections and try again.
- Page 6 IDENTIFY URD CABLE USING AVR RECEIVER The AVR receiver is a passive audio/visual receiver that will indicate single light or single beep to indicate the correct cable. Follow the “DC TRANSMITTER SET-UP AND TEST” Procedure outlined on page 4. Ensure the power light is on, the blue pulse light is pulsing, and the green short continuity light is illuminated.
- Page 7 IDENTIFY URD CABLE USING ACDM RECEIVER The ACDM Receiver is a handheld analog receiver that indicates a needle movement representation of the direction & pulse strength applied to the cable. Follow the “DC TRANSMITTER SET-UP AND TEST” Procedure outlined on page 4. Ensure the power light is on, the blue pulse light is pulsing, and the green short continuity light is illuminated.
- Page 8 The unit will do the rest 3. When removing, always turn the unit off first and remove the CT from the cable before unplugging from the unit. Technical & Service Bierer & Associates Inc. Manufacturing & Repair 10730 Farrow Rd. Blythewood, SC 29016...
Need help?
Do you have a question about the DCI-50-CT and is the answer not in the manual?
Questions and answers