Buttonhole Function (1) - Janome DE 5024 Servicing Manual

MECHANICAL ADJUSTMENT

BUTTONHOLE FUNCTION (1)

A buttonhole sewn with the automatic buttonhole foot will be 3mm longer than the actual
button.
The length can be adjusted as follows:
ADJUSTMENT PROCEDURE:
1. Lower the feed dog and attach foot (R), then lower the presser bar.
2. Open the face cover, and remove the micro switch.
3. Loosen screw (A).
4. Pull down the buttonhole lever (E) until it touches foot (R), and bar (B) touches the front
base plate (F). Make sure buttonhole lever adjusting plate (C) touches bar (B). Tighten
screw (A).
2. Raise the feed dog and sew a buttonhole. If the buttonhole is:
* too short, move the buttonhole lever adjusting plate (C) to the direction of (G).
* too long, mote the buttonhole lever adjusting plate (C) to the direction of (H).
6. Attach the micro switch.
2 3