Needle Position - Janome DE 5024 Servicing Manual

NEEDLE POSITION

TO CHECK:
1. Set the machine as follows:
* Stitch selector at stitch No. 7
* Stitch width control at 6.5
2. Turn the hand wheel toward you until the needle comes to center position (D).
3. The needle should not move when you turn the stitch width control to "0".
ADJUSTMENT PROCEDURE:
1. Remove the top cover (See page 4).
2. Turn the hand wheel toward you until the needle comes to the center of the slit in
the needle plate.
3. Loosen screws (A) and (B).
4. Tighten screw (A) slightly.
5. Move the plate (C) in either direction as shown by the arrow until the needle ceases
movement, even if the dial is moved from maximum zigzag width to zero.
MECHANICAL ADJUSTMENT
(A)
1 2