Http Command & Telnet; Cgi / Http Commands; A.) Set Power Command; B.) Read Power Command - Aviosys IP Power 9258S User Manual

9. HTTP Command & TELNET

CGI / HTTP Commands

Http commands allow you to control the device with commands. The basic
commands are provided below.
There are two ways to input http commands with authorization required
* Password in http: for Browser IE 7.0 or below
http://login:password@ipaddrss:port/set.cmd?cmd=command
* Password not in http: for Browser IE 7.0 and higher
http://ipaddrss:port/set.cmd?user=login+pass=password+cmd=command
Note: If you use the password not in http: command you will need to enter it
when the browser asks for the password.

a.) Set Power Command

The Set Power command allows you to control the devices on/off through the http
commands. With this command you can integrate can integrate the 9258xx with
any other system.
Command format:
http://ip:port/set.cmd?cmd=setpower+p61=1+p62=0+p63=1+p64=1
Outlet
Output 1
Output 2
Output 3
Output 4
Ex. For 4 Ports Control On / Off
http://192.168.1.3/set.cmd?cmd=setpower+p61=1+p62=0+p63=1+p64=1
Output: p61=1 p62=0 p63=1 p64=1
Ex. For Single Port Control Off
http://192.168.1.3/set.cmd?cmd=setpower+p61=0
Output:P61=0

b.) Read Power Command

1. Set Port On/Off
http://192.168.1.3/set.cmd?cmd=setpower+p61=1
open) , setpower+p61=0(relay closed)
Power On
61 = 1
62 = 1
63 = 1
64 = 1
- 26 -
IP POWER 9258 USER MANUAL
Power Off
61 = 0
62 = 0
63 = 0
64 = 0
(relay