Reset Factory Settings; Status Check Selection - Hand Held Products SCANTEAM 2070 BASE Manual

Reset Factory Settings

Scanning the Factory Default Settings bar code resets the Cordless System
to the original factory settings, clearing any programming changes you may have
made. You may reset the factory default settings for the current application group
or for all application groups.
The Current Application Group Default defaults only the settings described in
Section 4 of this manual.
Factory Default Settings: Current Application Group
The ALL Application Groups Default sets the terminal ID to 003, then changes
all settings to factory default values. (See the Defaults section in the back of this
manual for a listing of all the factory defaults.)
Factory Default Settings: ALL Application Groups
Status Check
Scan the Show Base Software Revision bar code to transmit the Cordless
Base software revision level to the host terminal. The Base software revision will
be printed out as " ." (The
Base software revision: X.XX, Radio: K.KK
"X's" and "K's" will vary according to the firmware revision.)
Show Base Software Revision
Scan the Show Scanner Software Revision bar code to transmit the Cordless
Scanner software revision level to the host terminal. The scanner software
revision will be printed out as "
Scanner software revision: Y.YY, Radio:
." (The "Y's" and "K's" will vary according to the firmware revision.)
K.KK
Show Scanner Software Revision
2–14 Cordless System Manual