Thomas & Friends CHY06 Instructions

BEFORE YOU PLAY BEFORE YOU PLAY
1 2
Attach the sleigh to the door, ensure Raise and close the door.
the tabs on the underside of the sleigh
fit into the slots on the door.
Thomas should move forward in the direction of the arrow.
1 2
As the engine passes, Sir Topham Hatt pops out
dressed as Santa!
4 5
The engine and Santa race through the
snow-covered tunnel.
BATTERY INFORMATION BATTERY INFORMATION
BATTERY INSTALLATION
Access the battery compartment by unscrewing and separating the top half of the engine
from the bottom half of the engine. Replace the batteries as indicated inside the battery
compartment. Re-assemble the two halves of the engine, re-insert the screw and tighten.
Batteries included are for demonstration purposes only. For longer life use only alkaline
batteries. If the product begins to malfunction, check the battery installation. You may
need to reset the electronics by removing the batteries and reinstalling them. If the
product continues to malfunction or no longer operates, remove the batteries from the toy
and replace them with fresh batteries. For longer life use only alkaline batteries.
Requires 2 "AAA" (LR03) batteries.
BATTERY SAFETY INFORMATION
In exceptional circumstances batteries may leak fluids that can
cause a chemical burn injury or ruin your product. To avoid battery leakage:
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the product before being charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Do not mix alkaline, standard (carbon-zinc), or rechargeable (nickel-cadmium) batteries.
• Do not mix old and new batteries. Required tool:
• Only batteries of the same or equivalent type as recommended are to be used.
Phillips screwdriver (not included)
• Batteries are to be inserted with the correct polarity.
• Exhausted batteries are to be removed from the product.
1,5V x 2
• The supply terminals are not to be short-circuited. • Dispose of battery(ies) safely.
"AAA" (LR03)
• Do not dispose of this product in a fire. The batteries inside may explode or leak.
CONSUMER ASSISTANCE
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Based on the Railway Series by The Reverend W Awdry.
Outside the United States:
©2015 Gullane (Thomas) Limited. Thomas the Tank Engine & Friends and Thomas & Friends
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
are trademarks of Gullane (Thomas) Limited.
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
©2015 HIT Entertainment Limited. HIT and the HIT logo are trademarks of HIT Entertainment Limited.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
©2015 Mattel. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, except as noted.
www.service.mattel.com/uk
PRINTED IN CHINA. Mattel East Asia Ltd., Room 503-09, North Tower, World Finance Centre,
Mattel Europa B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Harbour City, Tsimshatsui, HK, China. Tel.: (852) 3185-6500.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
CHY06-0970-G2
Albany 1331, Auckland.
1100474609-DOM
3 4
Place the barrel on the platform of
the Candy Cane Factory.
HOW TO PLAY HOW TO PLAY
Note: For best performance,
place Santa in the first cargo car.
3
GO
STOP
Load Santa into the first cargo car. Then flip the switch to As the engine passes, the barrel rolls down into the third
let the engine go. cargo car. Then flip the switch to let the engine go.
Note: If the engine runs continuously for approximately 5 minutes,
GO it will automatically shut off to preserve battery life. To resume play,
STOP
press the button on the engine.
Unload the holiday cargo, then release the stop-track to
send the engine on his way.
FCC STATEMENT (UNITED STATES ONLY)
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna. • Increase the separation between the equipment
and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
NOTE: Changes or modifications not expressly approved by the manufacturer responsible for
compliance could void the user's authority to operate the equipment. This device complies with
Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
CAN ICES-3 (B)/NMB-3 (B)
Operation is subject to the following two conditions:
(1) this device may not cause interference, and (2) this device must accept any interference,
including interference that may cause undesired operation of the device.
L'utilisation de ce dispositif est autorisée seulement aux conditions suivantes :
(1) il ne doit pas produire de brouillage et (2) il doit pouvoir tolérer tout brouillage radioélectrique
reçu, même si ce brouillage est susceptible de compromettre son fonctionnement.
Protect the environment by not disposing of this product
with household waste (2012/19/EU). Check your local
authority for recycling advice and facilities .
CAUTION:
To prevent entanglement,
keep hair away from wheels.
STOP
GO
INSTRUCTIONS
Set all 3 stop-tracks to "stop".
Keep these instructions for future reference
as they contain important information.
X1
X1
STOP B2
X1
GO
S2
X3
CS
X5
RS2
X13
GS1
X6
X1
LABEL PLACEMENT LABEL PLACEMENT
CHY06
H H H H
OLIDAY OLIDAY OLIDAY OLIDAY
DELIVERY SET DELIVERY SET DELIVERY SET DELIVERY SET
WHAT'S INCLUDED WHAT'S INCLUDED
X1 X1
X1 X1
ES1 X6
ES2
X4
T2
X1
S1
X8
TRL
X1
ES7
X2
X1
X1
X1
X1
X1
X1
X1
X1
S2
Note: Some engines may not work on this track set.
ADULT ASSEMBLY REQUIRED.
C C C C
ARGO ARGO ARGO ARGO
X1 Base
D1
X2 BS1
X1 X1
Piece
GB1
X6
X1 X1
S4
X3
X1
GBS
X2
X3
X1
X2
X5
X1
X1
GCS1
X2
GCS2
X2
X11
X1
X1 X1
X1
HELPFUL HINTS HELPFUL HINTS
•
ONE-TIME SNAP: Assembly step that is marked
with a star is "one-time snap ". Once this part is
put together, it cannot be taken apart.
•
Track marking codes are found on the bottom
of tracks and risers.
•
While connecting the track (ES7) that are
marked with a triangle , make sure the side
with the triangle always points towards the
lower track.
•
Some track sections (ES2, ES7) are intentionally
curved, they are not damaged.
No tools needed.