Thomas & Friends TrackMaster Thomas at Action Canyon Assembly Instructions Manual

Thomas & Friends TrackMaster Thomas at Action Canyon Assembly Instructions Manual

Railway system

Advertisement

Railway System
1
2
4

Assembly Instructions

Build the Waterfall!

W2
X
Connect Upper Blue Waterfall Track (X)
to Blue Waterfall Door (Y).
Stand up mountain wall.
3
Y
Not for use with some TrackMaster™ engines.
Item # 64061
Item # 64061
AGE: 3 YEARS +
AGE: 3 YEARS +
V
Snap Lower Blue
Waterfall (V) into
Front Mountain
Wall-Left (W2).
Snap Upper Blue
Waterfall Track (X)
into Front Mountain
Wall-Left (W2)

Advertisement

Table of Contents
loading

Summary of Contents for Thomas & Friends TrackMaster Thomas at Action Canyon

  • Page 1: Assembly Instructions

    Item # 64061 Item # 64061 AGE: 3 YEARS + AGE: 3 YEARS + Assembly Instructions Railway System Build the Waterfall! Snap Lower Blue Waterfall (V) into Front Mountain Wall-Left (W2). Connect Upper Blue Waterfall Track (X) to Blue Waterfall Door (Y). Snap Upper Blue Waterfall Track (X) into Front Mountain...
  • Page 2 Track Layout Checklist (Items shown below not to scale) Half Straight Straight Curve Sloped Straight Valley Straight Cliff Side Curve Rear Mountain Rear Mountain Special Function Mountain Mountain Sloped Mountain Sloped Curve Top Cover Wall--Right Wall--Left Crossbeam Quarter Track Turn Out (R) Mountain Support Mountain Support Mountain Support...
  • Page 3 Make the Mountain! Connect Front Mountain Wall-Right (W1) to Front Mountain Wall-Left (W2). Connect Interior Mine Track (Q) to Lower Blue Waterfall Track. Insert Mountain Quarter Track (I) and Special Function Cross Beam (H) into Rear Mountain Wall-Right (G1). Special Function Crossbeam...
  • Page 4 Connect Rear Mountain Wall-Right to Interior Mine Track. Connect Mountain Slope Turn Out (K) as shown.
  • Page 5 Build the Bridge! Attach Bridge Center Arches (T) to Bridge Track. Insert pegs into holes and slide toward waterfall. Insert Bridge Track (S) into Rear Mountain Wall-Right. Leave Bridge Track angled down. Snap Rear Mountain Wall-Left (G2)into place. Raise Bridge Track and snap into place. Attach left and right Bridge Front Arches (U3 and U4) to mountain.
  • Page 6 Create the Track Levels! Level 3 Level 2 Level 1 Connect each matching set of Mountain Supports with crossbeams (P). Please note the height difference of supports Level 3 Use Mountain Slope Curves (J) to connect the Rear Mountain Wall with Mountain Supports. Snap track into crossbeams.
  • Page 7 Continue adding mountain sloped curve track and mountain supports as shown. Level 3 Level 1 Level 2 For complete track layout see diagram on following page. Troubleshooting 1. For best performance Thomas (or other small engines) should not pull more than two train cars on this playset. 2.
  • Page 8 Action Canyon Instructions Press switch to collaspe bridge When the bridge is collapsed, the track lever will automatically move to the left and Thomas will go up the hill. If the bridge is not collapsed, children can decide which direction Thomas goes by switching the track lever right or left.

Table of Contents