Technical Data - Ryobi RSH2400R Operator's Manual

TECHNICAL DATA

Type Model No.................................................RSH2400R
Voltage..................................................230-240VAC 50Hz
Rated Power......................2400W (S6-40%) 2200W (S)
NOTE:
. The S6-40% indicates a load profile of 4 min load and
6 min idle time. For practical application, continuous
operation is permitted.
2. The Max Cutting Diameter depends on the hardness
of the wood.
Max. Idle Speed..............................................4500 min-
Max. Cutting Diameter.....................................Max. 40mm
Guaranteed sound pressure: LPA........................97 dB(A)
Guaranteed sound power Lever LWA................08 dB(A)
Weight.....................................................................3,5Kg
NOTE:
. Do not allow garden waste to accumulate before
shredding as it will begin to compost, become too
damp and clog the cutting assembly. Dry material will
help most material to clear the ejection chute. Save
some dry sticks until last to help clean the blade area.
2. Frequently monitor the build up/collection of shredded
material.
3. Do not allow shredded material to build up and fill the
inside of the shredders discharge chute.
4. When the collection box is full, press the On/Off switch
to turn the garden shredder Off before emptying.
WARNING!
Do not put your hands up inside the shredder's
discharge chute to clear away shredded material
while the shredder is switched on or connected
to the mains supply.
NOTE: In normal use, do not switch off the garden
shredder until all of the shredded material has cleared
the cutter assembly. If the garden shredder is switched
off too quickly, remaining pieces of material may clog the
blade assembly and stall the motor when the shredder is
switched back on.
ENGLISH
Figure 1
. Feeding chute
2. Shredder body
3. Cover locking knob
4. Discharge chute
5. Wheel supports protector
6. Transportation wheel
7. Motor cover
8. Mains cable and plug
9. Transportation handle
Figure 2
0. Leg
. Protector fixed screw
2. End frame
3. Nylon Nut
4. Axle tube
5. Washer
6. Wheel bush
7. Washer
Figure 3
8. Spanner I (with hex key)
9. Spanner II (with crossed key)
20. Plunger
Figure 5
2. Leg fixed screw
Figure 6
22. Leg fitting hole
Figure 7
23. Indication lamp
24. Overload protection button
25. On/Off switch
Figure 8
26. First lock
27. Key
28. Second lock
Figure 9
29. Safe blockage
30. Cutting device
4
DESCRIPTION