Avoid accidental starting. Ensure the switch is in THANK YOU FOR BUYING A RYOBI PRODUCT. the off-position before plugging in. Carrying To ensure your safety and satisfaction, carefully read power tools with your finger on the switch or through this OWNER’S MANUAL before using the plugging in power tools that have the switch on product.
Page 8
INSTRUCTIONS FOR SAFE HANDLING 13. Before starting the machine, check that all screws, nuts, bolts and other fasteners are properly secured and that 1. Make sure that the tool is only connected to the guards and screens are in place. voltage marked on the name plate.
ITEMS SUPPLIED (Fig. 1) 4. ASSEMBLE THE INFEED MATERIAL HOPPER You will need: a. 1 x infeed material hopper 6pcs M5x12 one-way screws; b. 1 x infeed material funnel 6pcs M5 Nylock nuts and 6pcs M5 flat washers c. 1 x main body (1) Align the slot &...
MAINTENANCE AND STORAGE STARTING PROCEDURE 1. Place the machine on firm level ground, ensure both feet Warning! and both wheels are touching the ground. Switch off, remove plug from mains before adjusting or 2. Fix the chip catcher to the machine, slide it on rails and cleaning, never start up when cable is cut, damaged or push in fully.
TROUBLESHOOTING The following chart lists problem symptoms, possible causes and corrective action, if your shredder does not operate properly. If these do not identify and correct the problem, contact your service agent. Warning! Switch off, remove plug from mains before adjusting, cleaning or if cable is cut, damaged or entangled. PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION...