Table of Contents
Advertisement
As the 10Base-2 cable has only two wires, we suggest you scan
using manual mode although 'Auto' mode can still be used.
Remote Test (using the Master and Remote Units).
Plug one end of the cable under test to the source RJ45 socket
(marked with the p arrow) of the Master Unit and the other end to
the receiving RJ45 socket of the remote unit. If the cable under test
is already installed on a patch panel or wall plate, you will have to
use a suitable adaptor cable (not supplied) to solve the connector
gender problem. Please refer to pictures 4 and 5.
Set the Auto/Manual switch to Auto mode if you are carrying out the
test alone.
Observe the test result on the LED display of the remote unit.
Note: The LED display on the remote unit is scanned in sequence
corresponding to the source end at the master unit.
7
Advertisement
Table of Contents
