Modular Cable Test; 10Base-2 Cable Test - Triax CAT6 Manual

Modular Cable Test

Please refer to the procedures for 10Base-T Cable Test. However,
in this test, the LED display should be as shown in picture 2.
Note: You will need to use a RJ45 to RJ11 adaptor, not supplied.
Picture 2

10Base-2 Cable Test

Plug the two RJ45 to BNC adaptor cables (supplied) into the RJ45
sockets on the Master Unit. Connect the BNC cable under test to
the BNC connectors on the adaptor cables.
For the remaining procedure refer to the 10Base-T cable test on
page 7.
Note:
The centre pin of the BNC cable should be read on LED 1 and the
shielding of the BNC cable should be read on LED 2. Please refer
to picture 3 below.
Picture 3
6