Related Manuals for Triax 157012
Summary of Contents for Triax 157012
- Page 1 LAN Cable Identifier Part No. 157012 Operating Manual TRIAX - your ultimate connection...
-
Page 2: Table Of Contents
Contents Product Profile Cable Tracing Functions Telephone Cables Network Cables Electrical Cables Network Cable Continuity Function Other Functions Open and Short Circuit Test DC Level Test Detecting a Signal on a Telephone Line Low Voltage Alarm Headphones Technical Specification... -
Page 3: Product Profile
Product Profile The LAN Cable Identifier kit contains the following items: Emitter RJ11 Input RJ45 Input Function button Testing Indicators Wire test sequence indicator Rotary function select switch Receiver Probe Wire test sequence indicator Rotary ON/OFF switch and volume control Headphone Socket RJ45 Input Accessories... -
Page 4: Cable Tracing Functions
Cable Tracing Functions Telephone Cables: 1. Insert the Telephone cable to be traced, (fitted with a RJ11 plug), into the RJ11 socket on the LAN Cable Identifier Emitter Unit. 2. Turn the Emitter rotary selection switch to “Scan”, the Status LED will flash indicating that the Emitter is operating normally. - Page 5 Example 1 - Locate a cable on a switch: 1. Connect the Telephone Cable to be 2. Use the Receiver Unit probe to traced into the test port of the Emitter detect the far end of the Telephone Unit. Cable being traced. Example 2 - Locate a cable on a patch panel: 1.
-
Page 6: Network Cables
Network Cables: 1. Insert the Network cable to be traced, (fitted with an RJ45 plug), into the RJ45 socket on the LAN Cable Identifier Emitter Unit. 2. Turn the Emitter rotary selection switch to “Scan”, the Status LED will flash indicating that the Emitter is operating normally. - Page 7 Example 1 - Locate a cable on a router: 1. Connect the Network Cable to be 2. Use the Receiver Unit probe to traced into the test port of the Emitter detect the far end of the Network Cable Unit. being traced.
-
Page 8: Electrical Cables
Electrical Cables: 1. Insert the RJ11 Cable to Crocodile Clip accessory cable into the RJ11 socket on the LAN Cable Identifier Emitter Unit. 2. Connect the crocodile clips to the electrical cable to be traced. Please note the safety limitations below. Safety Note: This test is only suitable for cables carrying a low current. -
Page 9: Network Cable Continuity Function
NOTE: The LAN Cable Identifier must only be used on cables carrying a low current, (see safety note above). Connect the Electrical Cable to be traced into the test port of the Emitter Unit. Use the Receiver Unit probe to detect the far end of the Electrical cable being traced. -
Page 10: Other Functions
Other Functions Open and Short Circuit test: 1. Turn the rotary switch on the Emitter Unit to “Test”. 2. Press the “Function” button on the Emitter Unit for 2 seconds. The “Verify” LED will change from flashing to steady state. 3. -
Page 11: Technical Specification
Technical Specification Item Specification Product Name LAN Cable Identifier Part Number 157012 Power Supply 2 x DC, 9V Battery (included) Maximum working current Emitter Unit: ≤ 10mA Receiver Unit: ≤ 30mA Maximum DC Voltage 9V (Generally 5V) Signal Transmission Format... - Page 12 Issue 2 *Triax reserves the right to change the specifications without prior notification...