Sensor Lights - Dialight WOSU22BG2 User Manual

Installing Batteries
1. Remove AA batteries from their packaging.
2. Install batteries in the battery holder on the sensor making sure to orient them
according to the +/- symbols on the holder. Install provided battery clips.
Battery Holder (BAT2)
3. Lock sensor to the back plate. Installation is the opposite of removal.
4. The sensor is now on and ready to be discovered.
NOTE: There is no on/off switch in the sensor. To power off the sensor, remove the batteries
from unit.
To turn on the LED Indicators
1. Twist open the sensor from the mounting plate.
2. Move the LED switch to the right to turn on the LED indicators.
NOTE: Turning switch to on will cause increase current draw to the batteries and will
shorten life based on the amount of motion detection.
LED On/Off Switch
3. Twist close the sensor back on to the mounting plate.
8

Sensor Lights

9100-127-2989-99 REV B
1501 Route 34 South, Farmingdale, NJ 07727
Tel: (732) 919-3119 Fax: (732) 751-5778 www.dialight.com
Battery Holder (BAT 1)