Introduction - Dialight WOSU22BG2 User Manual

Welcome to the Dialight Wireless Occupancy Sensor user manual. This product allows you to customize your entire
lighting network using independent Occupancy Sensors throughout your facility by turning lights on when
occupancy has been detected.
This guide provides you with the information you need to get started.
•
Refer to operating temperature ratings of this
device before installing.
•
DO NOT let the sensor touch hot surfaces.
•
DO NOT mount near gas or electric heaters
•
Equipment should be mounted in locations
and at heights where it will not be subjected
to tampering by unauthorized personnel.
•
The use of accessory equipment not
recommended by the manufacturer may
cause unsafe conditions.
•
DO NOT use this equipment for other than
intended use.
•
DO take pictures of the installation, wiring
and mounting for future reference.
•
Battery life will vary upon traffic area of the
install
•
Contact your local Sales representative or
Dialight when necessary
SAVE THESE INSTRUCTIONS!!
3

Introduction

Keep These Instructions
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
9100-127-2989-99 REV B
•
The installation and maintenance must be
carried out by authorized personnel.
•
Repairs and Installation must only be
carried out by a qualified electrician.
•
Only genuine or authorized Dialight
replacement parts must be used when
unforeseen repairs are required.
•
Observe the national safety rules and
regulations during installation!
•
Mounting in extreme heat locations should
be avoided. Failure to do so could void all
warranties!
•
No alterations are allowed without the
written agreement from Dialight Corp.
Alterations other than written in this manual
will void all warranties.
•
Batteries should be removed when the
sensor is not being used
•
It is suggested that a maintenance schedule
be set up for battery replacement.
SAVE THESE INSTRUCTIONS!!
1501 Route 34 South, Farmingdale, NJ 07727
Tel: (732) 919-3119 Fax: (732) 751-5778 www.dialight.com