Troubleshooting Continued - Dialight WOSU22BG2 User Manual

2. On the gateway web page verify that the sensor in question is assigned to a group and
that a motion event is currently ON in the schedule (see gateway manual).
3. On the gateway web page verify that the nodes in the network show with no
connection errors (consult gateway manual).
4. Follow the provided instructions to turn the sensor LED switch to ON.
5. Check the condition of the LED lights through the front lens of the sensor.
6. If the red LED is blinking then the batteries need to be replaced.
7. If the green LED is double blinking then the sensor is trying to join a network. Follow steps
in the gateway manual to discover the sensor and see if the problem persists.
8. From your gateway's wireless devices page, display the motion sensors (consult the
gateway manual for instructions).
9. Wait until no motion sensor in the network is showing motion present.
10. Trigger motion on the sensor in question.
11. If the green LED behind the front lens of the sensor does not blink once then:
a. Try new batteries.
b. Replace the sensor.
12. If the green LED does blink then verify that one sensor on the gateway web page shows
motion present for a relatively short period of time.
13. If motion is shown on one sensor node then verify that that sensor is assigned to global
mode or the group that you want to light up.
14. If none show motion present then this sensor is likely part of a different gateway
network. Follow steps in this manual to remove the sensor from a different gateway.
17

Troubleshooting Continued:

9100-127-2989-99 REV B
1501 Route 34 South, Farmingdale, NJ 07727
Tel: (732) 919-3119 Fax: (732) 751-5778 www.dialight.com