Unicont DTS-100 User Manual page 15

User manual Rev 1.3
3.8.1. First time starting up
Default settings (On the mainboard of system):
- SW2 jumper – ON
- Jumpers group SW1 – all in ON position, except 4.
That configuration allows you to store all new settings.
After switching on the power please wait until the system boots up. All following
manipulations are described for system phone keyset.
3.8.2. Entering the programming mode
To get into the programming mode please press on buttons
in following sequence: Speaker, TRANS/PGM, *, #, TRANS/
PGM
3.8.3. PAGE settings (Public Address output)
- Enter the programming mode sec 3.8.2
- Press 181, CO10 (on the right keyboard - LOOP BUTONS)
- Set the working timeout (0 – 255 sec.)
- Press HOLD/SAVE
- Press TRANS/PGM (allowing of Public Address transmission)
- Enter 111, then "enter STA ranger" appears.
- Enter 100, 100 for instance. That means that only station no. 100 is able
to get on for P.A. contact
- Press CO8 loop button
- Push on 1 ("OFF" is changing to "ON" on the screen).
- Press on HOLD/SAVE
15