Assembly Instructions; Mounting The Charging Station; Adjusting The D-Handle - Ryobi 155r Operator's Manual

ADJUSTING THE D-HANDLE

1. Hold the unit in the operating position (Fig. 1).
2. Loosen the wing nut (Fig. 2). It is not necessary to
remove the wing nut, washer or bolt.
3. Position the D-handle to the location that provides
you the best grip, and tighten the wing nut (Fig. 2).
D Handle

ASSEMBLY INSTRUCTIONS

Fig. 1
Wing Nut
Fig. 2

MOUNTING THE CHARGING STATION

NOTE: Mount the charging unit and allow the unit to
charge for at least 36 hours prior to first use.
This unit may stay on the charging station continuously
without overcharging. Place the charging station where
the unit is intended to be stored. This should be a cool,
dry and well ventilated place, where the unit can be
locked-up and out of the reach of children.
The unit should be stored and charged in a location
where the temperature is between 50˚F (10˚C) and 100˚F
(38˚C).
1. Locate a place for the charging station near a wall
outlet and high enough to keep the unit off the floor.
2. Locate the wall stud and mount the charging station
to the wall using the three (3) screws provided
(Fig 3). Make sure that the screws enter the wall stud
to provide a secure mount.
Charging Station
Screws
Wall Outlet
Charger
Charging
Indicator Light
CAUTION: To prevent injury or damage to
the unit, the charging station must be
mounted securely to the wall.
3. Plug the charger into the wall outlet and wrap any
excess wire onto the cord wrap on the charging
station (Fig. 3).
Cord Wrap
Fig. 3
Wall
Stud
7