INSTALLING AND ADJUSTING THE
J-HANDLE
1. Place the J-handle between the top and
middle clamp pieces (Fig. 1).
(4) Screws
Top Clamp
Middle Clamp
Bottom Clamp
2. While holding the three pieces together,
install the four (4) screws through the top
clamp and into middle clamp.
NOTE: The holes in the top and middle clamp
will line up only when assembled
correctly.
3. Place the clamps and j-handle the over the
shaft housing and onto the bottom clamp.
4. Hold each hex nut in the bottom clamp
recess with a finger. Start screws with a large
Phillips screwdriver. Do not tighten until you
make the handle adjustment.
5. Slide the J-handle in or out until the
arrow/white line on the decal touches the
clamp assembly (Fig. 2).
Decal
10
ASSEMBLY INSTRUCTIONS
J-Handle
Nuts
Fig. 1
Fig. 2
6. While holding the unit in the operating
position (Fig. 3), position the J-handle to the
location that provides you the best grip.
7. Tighten the clamp screws evenly, until the
J-handle is secure.
Fig. 3