Specifications - Makita PW5000C Instruction Manual

ENGLISH (Original instructions)

SPECIFICATIONS

Rated speed (n)/No load speed (n
• Due to our continuing programme of research and development, the specifications herein are subject to change without notice.
• Specifications may differ from country to country.
• Weight according to EPTA-Procedure 01/2003
Symbols
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
･
Read instruction manual.
･
DOUBLE INSULATION
･
Wear safety glasses.
･
Only for EU countries
Do not dispose of electric equipment
together with household waste material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life must
be collected separately and returned to
an environmentally compatible recycling
facility.
Intended use
The tool is intended for surface work with natural stone.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and can
only be operated on single-phase AC supply. They are
double-insulated and can, therefore, also be used from
sockets without earth wire.
Noise
The typical A-weighted noise level determined according
to EN60745:
Sound pressure level (L
Sound power level (L
Uncertainty (K) : 3 dB(A)
Model
Spindle thread
Pad diameter
)
0
Overall length
Net weight
Safety class
equipment
) : 85 dB(A)
pA
) : 96 dB(A)
WA
END202-6
Vibration
The vibration total value (tri-axial vector sum) determined
according to EN60745:
Work mode : stone polishing
Vibration emission (a
Uncertainty (K) : 1.5 m/s
The declared vibration emission value has been
•
measured in accordance with the standard test
method and may be used for comparing one tool
with another.
The declared vibration emission value may also be
•
used in a preliminary assessment of exposure.
and its
The declared vibration emission value is used for
•
main applications of the power tool. However if the
power tool is used for other applications, the
vibration emission value may be different.
WARNING:
The vibration emission during actual use of the
ENE057-1
•
power tool can differ from the declared emission
value depending on the ways in which the tool is
ENF002-2
used.
Be sure to identify safety measures to protect the
•
operator that are based on an estimation of
exposure in the actual conditions of use (taking
account of all parts of the operating cycle such as
the times when the tool is switched off and when it
is running idle in addition to the trigger time).
ENG905-1
2
PW5000C,PW5000CH
M14
max. 125 mm
-1
2,000 - 4,400 min
313 mm
2.3 kg
/II
Wear ear protection
2
) : 5.0 m/s
h,P
2
ENG900-1
ENG902-1