Ryobi CFS1502 Operator's Manual page 10

ATTACHING HOOK AND LOOP SANDING
SHEETS
See Figure 2.
n Unplug the sander.
n Align holes in hook and loop type sanding sheet with holes
in pad, then carefully press fuzzy side of the sanding sheet
against pad as tightly as possible.
Note: Hook and loop type sanding sheets can be
reused for the life of the sanding abrasive. It is rec-
ommended that you keep the sanding sheet back-
ing clean to provide for best adhesion. Clean the
sheet and hook and loop pad by brushing lightly
with a light brush.
ATTACHING THE DUST BAG
See Figure 3.
The dust bag provides a dust collection system for the sand-
er. Sanding dust is drawn up through the holes of the sanding
sheet and collected in the dust bag during sanding.
n Unplug the sander.
n Using a slight twisting motion, firmly slide dust bag as-
sembly over blower exhaust on sander.
TURNING THE SANDER ON/OFF
See Figure 4.
While holding the tool in normal operating position,
n Push the ON/OFF switch to the left to turn sander on.
n Push the ON/OFF switch to the right to turn sander off.
OPERATING THE SANDER
See Figures 5 - 6.
CAUTION:
Keep the cord away from the sanding pad and position
the cord so that it will not be caught on lumber, tools, or
other objects during sanding.
n Secure the workpiece to prevent it from moving under
the sander.
WARNING:
Unsecured workpieces could be thrown towards the
operator, causing injury.
WARNING:
Keep your head away from the sander and sanding area.
Hair could be drawn into sander causing serious injury.
n Hold the sander in front and away from you, keeping it
clear of the workpiece.
OPERATION
10
HOOK AND LOOP
PAD
SANDING SHEET
Fig. 2
DUST BAG
BLOWER EXHAUST
Fig. 3
ON/OFF SWITCH
Fig. 4