Wasp WPA1200 Quick Start Manual

7. Power on the 1200
The red button on the unit is the power
button. Press the button the power on
the unit.
After powering on the unit, follow the
WPA1200 onscreen prompts to set up the
unit and set the time zone. The correct
time zone is very important. Based on the
time zone you set, the date and time will
WPA1200
be synced with the PC each time the unit
is connected and synced.

Quick Start

9. Install ActiveSync software
Guide
Vista does not require ActiveSync.
Using the included Microsoft ActiveSync
CD, install ActiveSync. Follow the
onscreen prompts in the installer.
If you purchased any integrated Wasp
software, you should install that software
after ActiveSync is installed.
10. Other Accessories and Parts
There is a SD memory slot on the front of
the scanner beside the scanning window.
It is for extra memory only up to 1GB.
11. Start the Scanner
This feature is enabled by default. If you
need to manually turn it on, follow the
instructions below:
From the start menu go to Settings, then
"Control Panel". Double click on "Scanner
Settings" to open the "Scanner Control
Panel". Then click on the third tab titled
© 2007 Wasp Barcode Technologies
"To Kpd", select the checkbox labeled
"Start Scan2Key When Exit" and then
click the OK button to close the form.