Operating Instructions - Johnson Level & Tool 40-6603 Instruction Manual

1834i-English_Manuals 4/27/17 2:22 PM Page 6

5. Operating Instructions

IMPORTANT: It is the responsibility of the user to ensure proper
maintenance of the Self-Leveling Cross-Line Laser. Conduct
periodic test measurements to ensure the instrument is measuring
accurately and consistently. This is most important if the
instrument has been exposed to extreme temperatures or
moisture. Keep the Self-Leveling Cross-Line Laser optic lens clean
and inspect for damage.
Battery Installation
To install batteries in the Self-Leveling
Cross-Line Laser:
1. Remove the battery cover, which is located at
the back of the tool, by pressing the battery
cover release tabs found on the left and right
sides of the tool and pulling the cover straight
out from the tool housing.
2. Insert 2 "AA" batteries into the battery compartment according to
the polarity illustrated inside the battery compartment.
3. Replace the battery cover. Press in the release tabs as you insert
them into the tool housing.
Notes
• Always check that the locking compensator/power switch is in the
locked position before removing and replacing batteries.
• Use only alkaline batteries.
• Remove the batteries when storing the instrument for an extended
time (more than 3 months) to avoid damage to the tool should the
batteries deteriorate.
6 ©2017 Johnson Level & Tool