Table of Contents
Advertisement
Chuck
Motor
Switch
No Load Speed
Clutch
Charger Input
Charge Rate
IMPORTANT INFORMATION FOR RECHARGING HOT BATTERIES
When using your drill-driver continuously, the batteries in
your battery pack become hot. You should let a hot battery
pack cool down for approximately 30 minutes before at-
tempting to recharge.
Note: This situation occurs when continuous use of your
drill-driver causes the batteries to become hot. It does not
To preserve natural resources, please
Y
recycle or dispose of properly.
R B R C
This product contains nickel-cadmium
battery. Must be disposed of properly.
N i C d
Local, state, or federal laws may prohibit
disposal of Nickel-Cadmium batteries in
ordinary trash.
Consult your local waste authority for information regarding
available recycling and/or disposal options.
For more information on battery recycling call 1-800-
8BATTERY.
WARNING:
Do not attempt to disassemble the battery pack. Fire or
injury may result.
WARNING:
The operation of any power tool can result in foreign objects being thrown into your
WEAR YOUR
eyes, which can result in severe eye damage. Before beginning power tool operation,
SAFETY
GLASSES
always wear safety goggles or safety glasses with side shields and a full face shield
when needed. We recommend Wide Vision Safety Mask for use over eyeglasses or
FORESIGHT IS BETTER
standard safety glasses with side shields.
THAN NO SIGHT
SPECIFICATIONS:
RY721
3/8 in. Keyless
DC Motor 7.2V
Two-Speed
330/500 RPM
24 Positions
120V, 60 Hz, AC Only
3-6 Hours
DISPOSAL OF THE EXHAUSTED BATTERY
RY961
3/8 in. Keyless
DC Motor 9.6V
Variable Speed
0 - 550 RPM
24 Positions
120V, 60 Hz, AC Only
3-6 Hours
occur under normal circumstances. Refer to "Charging
Your Drill-Driver" for normal recharging of batteries. If the
charger/charging assembly does not charge your battery
pack under normal circumstances, return both the battery
pack and charger/charging assembly to your nearest Ryobi
Authorized Service Center for electrical check.
BATTERY PACK PREPARATION FOR
RECYCLING
WARNING:
Upon removal, cover the battery pack's terminals with
heavy duty adhesive tape. Do not attempt to destroy or
disassemble battery pack or remove any of its
components. Also, never touch both terminals with metal
objects and/or body parts, as short circuit may result.
Keep away from children. Failure to comply with these
warnings could result in fire and/or serious injury.
Page 6
RY1201
3/8 in. Keyless
DC Motor 12.0V
Variable Speed
0 - 550 RPM
24 Positions
120V, 60 Hz, AC Only
3-6 Hours
Advertisement
Table of Contents
