Ryobi RPD800 Original Instructions Manual

Ryobi RPD800 Original Instructions Manual

Percussion drill

Advertisement

ORIGINAL INSTRUCTIONS
Percussion Drill
RPD800

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RPD800 and is the answer not in the manual?

Questions and answers

Summary of Contents for Ryobi RPD800

  • Page 1 ORIGINAL INSTRUCTIONS Percussion Drill RPD800...
  • Page 2 Important! It is essential that you read the instructions in this manual before operating this machine. Subject to technical modifications.
  • Page 3: General Power Tool Safety Warnings

    Safety tool. Do not use a power tool while you are GENERAL POWER TOOL SAFETY WARNINGS tired or under the influence of drugs, alcohol or medication. A moment of inattention while operating power tools may result in serious WARNING personal injury. Read all safety warnings and all instructions.
  • Page 4: Drill Safety Warnings

    Safety power tool repaired before use. Many accidents INTENDED USE are caused by poorly maintained power tools. a) Drilling in all types of wood. f) Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges b) Drilling in metals: steel, brass, aluminum sheets, are less likely to bind and are easier to control.
  • Page 5: Environmental Protection

    Contact authorized service center. ■ For greater safety and reliability, all repairs should be performed by an Authorised Ryobi Service Centre. LUBRICATION All of the bearings in the product are lubricated with a suffi cient amount of high grade lubricant for the life span of the product under normal operating conditions.
  • Page 6 Unpacking...
  • Page 7 Getting started...
  • Page 8 Getting started...
  • Page 9 Operation...
  • Page 10 Operation...
  • Page 11: Product Specifications

    PRODUCT SPECIFICATIONS Model RPD800 Voltage 230 V 50 Hz Input 800 W No-load speed 0 - 3,000 min Blows per minute (Impact rate) 0 - 51,000 min Chuck capacity 13 mm Drilling capacity in wood 34 mm in metal 13 mm...
  • Page 12 Techtronic Industries (Australia) Pty. Ltd. Level 1, 660 Doncaster Road Doncaster, VIC 3108, Australia Techtronic Industries New Zealand Ltd. 18-26 Amelia Earhart Avenue Mangere, Auckland 2022, New Zealand 20130829...

Table of Contents