Table of Contents
Advertisement
Domestic Hot Water Coil Kit - Optional
1
ACCESS
PANEL
REAR WALL OF
FIREBOX
5
DOMESTIC HOT WATER
COIL
TURN INSIDE NUTS UP
1. NUT
TO END OF THREADS
2. WASHER
3. GASKET
2
3
4
6
This Furnace will accept the installation of a
Domestic Hot Water Coil Kit. The U.S. Stove kit is a
1124 Water Coil and it may be purchased from your
local dealer.
1. Remove the access panel on the rear of the
furnace enclosure.
2. With a utility knife, cut away a section of the
insulation directly behind the access panel.
3. Remove the cover plate from the rear of the
furnace firebox.
4. Place one nut on each end of the water coil
and thread each nut up to the end of the
threads on the coil.
5. Insert the coil through the holes from the inside
of the firebox. Install a gasket, washer and nut
onto each end of the water coil. Tighten the
nuts down securely to insure an air tight seal.
The installation is now ready to be plumbed to your
existing hot water system. Choose one of the three
methods described in the Hot Water Coil instructions.
6. Remove knockouts from the access panel and
re-attach to the furnace enclosure.
Have a qualified plumber connect your domestic
hot water pipe to the coil with the appropriate
fittings.
-20-
Advertisement
Table of Contents
