gis
11
11.1 Introduction
11.2 Error conditions
Instruction manual ADM
Troubleshooting
This chapter covers the following errors:
•
Gas smell;
•
Water leakage;
•
Explosive ignition;
•
Poor flame profile;
•
Power anode (optional);
•
No hot water;
•
Insufficient hot water.
If the water heater goes into an "error" condition, you will be unable to draw hot
water.
The following pages provide troubleshooting tables for each type of error.
Note
Footnotes referred to from within any table are shown at the bottom of the
last page of that table.
49