Advertisement
Quick Links
Installation
Instructions
Page 1
daisy
P O W E R
1.
Wrap paper template
around roller tube, the end you
want to install the Daisy Power
motor and controls
2.
Without the drive motor
inside the tube, mark and drill
the 6 x 4.5mm holes through
the template with the 4.5mm
drill bit (3 around the end of the
tube and 3 around the inside
of the tube approximately
243mm from end of tube)
3.
Insert the drive motor, (if
there is a feather plug in way,
remove, then replace after
motor install) then using the
4.5mm drill again, drill through
the 6 holes in the tube, through
the drive motor flange
pool covers & rollers
daisy
Advertisement
Related Manuals for Daisy DPST52
Summary of Contents for Daisy DPST52
- Page 1 P O W E R daisy Wrap paper template around roller tube, the end you want to install the Daisy Power motor and controls Without the drive motor inside the tube, mark and drill the 6 x 4.5mm holes through the template with the 4.5mm...
- Page 2 Insert and tighten the 6 x mounting screws Ensure drive motor wire is running through the recess in the housing on the end Install the end frame, secure firmly 4 x Install the control housing, secure firmly the mounting bolts 4 x mounting bolts Plug in the drive motor wire to the connector socket on the underside of the control housing Note: each connector socket has labels for the correct appliance...
- Page 3 (Note: There is a keep alive function that will keep unit operational even in the shade without the indicator light illuminating) daisy Page 3 pool covers & rollers...
- Page 4 Lift Pin (pull up) button on the remote as you are pulling the cover back onto the pool from one side Contact Details sales@daisypoolcovers.com.au daisy Phone 1300 551 811 Page 4 | www.daisypoolcovers.com.au pool covers & rollers...