Advertisement
AC ChArger LED
Green = available
Green flickering red = charging from AC (the more it's charging
the longer the red is, very slow red flick means nearly fully
charged)
BAttery LED
Green = battery fully charged
Orange= intermediate (mostly charged)
Red = needs recharge. (less than 25% charge in battery)
Best indication of the battery condition is just after an operation
(pressing a button)
Battery condition light only illuminates when:
1. PV (solar panel) available or
2. AC available or
3. During and immediately after operation (for approximately
60 seconds after operation ceases)
Note: if there is marginal PV available (e.g. cloud coverage) then
the battery indicator light may come up orange even though
battery is fully charged
Note: when motor is operating, the battery LED will show red
as it's loading the battery and drawing the power.
Forward and reverse buttons control the drive motor direction
Remote control operation is the same operation as the buttons
on the control housing. Control button and remote button will
only operate the motor while the button is being pressed
Ensure the AC charger pack is not exposed to water or
weather. Plug in AC charger into the AC Charger connection to
re charge battery
Regularly check tension of all screws and mounting bolts
To free wheel the roller tube, disengage the motor drive by lifting
the locking pin – lift up to free wheel (rocking the tube back
or forward may be required to take the weight off the pin to
disengage)
For best operation, the pool cover should be cut to water line or
less
Ensure the cover has no folds or any obstruction to catch on
when rolling up
Tip for larger pools: to make it easier to put the cover back
onto the pool, disengage the drive motor then push the deploy
button on the remote as you are pulling the cover back onto the
pool from one side
Contact Details
sales@daisypoolcovers.com.au
Phone 1300 551 811
Page 4
| www.daisypoolcovers.com.au
Lift Pin (pull up)
daisy
pool covers & rollers
Advertisement
