Operating Instructions - Troy-Bilt TBBC Operator's Manual

WARNING:
Use with an electric product could lead to damage to the unit or serious personal injury.
OPERATING THE EZ-LINK
The following attachments are also available:
Cultivator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TBGC
Edger . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TBLE
Hedge Trimmer . . . . . . . . . . . . . . . . . . . . . . . . . . . TBAH
Straight Shaft Trimmer . . . . . . . . . . . . . . . . . . . . . . TBSS
Turbo Blower . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TBTB
Pole Saw . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . TBPS
WARNING:
and understand that attachment's specific
manual before you begin operation. Follow all
applicable safety information.
WARNING:
damage to the unit, shut the unit off before
removing or installing add-ons.
Removing the Add-On
1. Turn the knob counterclockwise to loosen (Fig. 9).
2. Press and hold the release button (Fig. 9).
3. While firmly holding the upper shaft housing, pull the
add-on straight out of the EZ-Link™ coupler (Fig. 10).
Installing the Add-On
NOTE: Place the unit on the ground or on a work bench
to make add-on installation or removal easier.
1. Turn knob counterclockwise to loosen (Fig. 9).
EZ-Link™ Coupler
Knob
10

OPERATING INSTRUCTIONS

Never use this attachment with an electric-powered unit. Only
attach the TBBC to gas-powered trimmers or brushcutters.
™
SYSTEM
When using any
attachment, read
To avoid serious
personal injury and
Release Button
Guide Recess
Fig. 9
2. While firmly holding the add-on, push it straight into
the EZ-Link™ coupler (Fig. 10).
NOTE: Aligning the release button with the guide recess
will help installation (Fig. 9).
EZ-Link™ Coupler
Upper Shaft Housing
3. Turn the knob clockwise to tighten (Fig. 9).
CAUTION:
hole and securely tighten the knob before
operating this unit.
CAUTION:
hole only. Using the wrong hole could lead to
personal injury or damage to the unit.
Release Button
Primary Hole
Lower Shaft Housing
Fig. 10
Lock the release
button in the primary
Knob
Fig. 11
Add-ons are to be
used in the primary