Before Using The Airscouter; Adjusting The Display; Turn The Power On - Brother AiRScouter WD-360B Quick Setup Manual

Before using the AiRScouter

How to assemble the AiRScouter
Ensure the AiRScouter is powered and connected correctly according to
the following procedure:
1.
Insert the internal battery into the control box:
a) Remove the screw
from the back of the
control box and slide
open the cover
panel.
b) Insert the Li-ion
rechargeable
battery.
c) Replace the cover
panel and tighten the
screw on the back of
the control box.
2.
Connect the AC adapter to the AC adapter port on the control box, and
fully charge the internal battery.
3.
Open the belt pouch and slide the control box into it as shown, so that
the ports are still accessible when the flap is closed.
4.
Pass your belt through the belt loop on the rear of the belt pouch.
5.
Attach the control box firmly to your body as shown below.
6.
Connect the head display cable from the head display to the head
display cable port on the control box.
7.
Connect the video input cable to the control box.
Note
• If an input source with an unsupported resolution is connected, the
image may not display correctly on the head display screen. If this
occurs, check the output resolution of the video source.
• Degradation of the video signal may occur when longer input cables
are used. For maximum quality, it's recommended to use HDMI and
USB cables of 2 m length or shorter.
How to wear the AiRScouter
1.
Place the head band onto the head as shown. The band should be
positioned just above the forehead.
Note
If the head band feels loose or starts to slip down the forehead, it is
recommended that you attach the rear band and use it to tighten the fit
on your head.
If you wear glasses
2.
To secure the head display cable to your clothing, use the cable clip.

Adjusting the display

Turn the power on

Press the power button
to turn the AiRScouter
on. (The LED under
the power button will
turn green.)
Adjust the position of the Head Display
1.
Loosen the ball joints by turning the
dials on either end of the flexible arm
counter-clockwise.
2.
Adjust the position and angle of the
head display so that it is easy to view.
3.
Tighten the ball joints by turning the
dials on either end of the flexible arm
clockwise to fix the head display in
place.