Remington Smooth and silky WXA-1080 Use & Care Manual

TM
Use and
Care Guide
WXA-1080
Electric Roll-On
Wax Kit
Register Your New Product Today!
By registering your new Remington product you will receive these important benefits:
TM
Proof of ownership • Product protection • Product registration • Special offers
Register online at: RemingtonProducts.com
IMPORTANT SAFETY
INSTRUCTIONS
When using an electrical appliance, basic precautions should always be observed,
including the following.
READ ALL INSTRUCTIONS
BEFORE USING.
KEEP AWAY FROM WATER.
CAUTION
DANGER
To reduce risk of electrocution:
n To reduce the risk of electric shock, do
n Always unplug immediately after using. not immerse in water or other liquids.
n To reduce the risk of burns, keep
n Do not use while bathing or in the shower.
children away when wax is hot.
n Do not place or store appliance
Refer to the instruction manual
where it can fall or be pulled into a
before each use.
tub or sink.
n To reduce the risk of burns or other
n Do not place in or drop into water or
injury, do not drape the cord over
other liquid.
a counter or a tabletop such that
n Do not reach for an appliance that has
it can be pulled on by children or
fallen into water. Unplug immediately.
tripped over unintentionally.
n Always unplug this appliance
n The physiological effects of
before cleaning.
this appliance have not been
investigated by Intertek.
WARNING
n Do not use an extension cord with
this appliance.
To reduce the risk of burns, fire,
n Use only Remington Smooth & Silky
electric shock or injury to persons:
wax cartridges.
n Do not attempt to open or repair.
n Do not apply hot wax near eyes or
Contact customer service for more
other heat sensitive areas to avoid skin
information.
injury, eruption or surface growth.
n An appliance should never be left
n Do not touch hot surfaces. Only
unattended when plugged in.
handle on outside of unit.
n Close supervision is necessary when this
n Use this appliance on a level surface.
appliance is used by, on, or near children
n Do not let cord hang over edge of table
or persons with certain disabilities.
or counter where it can be pulled on by
n Use this appliance only for its
children or tripped over unintentionally.
intended use as described in
n For household use only.
this manual. Do not use
attachments not recommended n When in use, the wax refill will be
by manufacturer. hot - allow it to cool down before
removing the refill from the device.
n Never operate this appliance if it
has a damaged cord or plug, if it is n Unplug from the outlet when not in
not working properly, if it has been use. Allow to cool before handling,
dropped or damaged, or dropped cleaning or storing the appliance.
into water.
n Test hot wax on a small area of
n Keep the cord away from heated skin for warmth and possible skin
surfaces. Do not wrap the cord reactions before using. If you are
around the appliance. susceptible to allergic reactions or
if you have circulatory problems, it
n Never use while sleeping.
is recommended that you consult
n Never drop or insert any object,
a physician before using this
other than a Smooth & Silky wax
appliance.
cartridge, into any opening.
n Do not use outdoors or operate
where aerosol (spray) products
are being used or where oxygen is
being administered.
n Do not use this appliance if damaged
or broken as injury may occur.
n Always store your appliance and
cord in a moisture-free area. Make
sure your cord is disconnected from
the appliance.
SAvE ThESE INSTRUCTIONS
Product Features
A. Power cord
B. Storage cap
C.
C. Cartridge heating chamber
D. Fill window
E. Charging light
F. Roller applicator
G. 2.7 oz (80ml). wax cartridge
H. Power inlet
I. Cloth Strips
D.
A.
H.
E.
F.
I.
B.
G.
How To Use
NOTE: This appliance has a polarized plug (one blade is wider than the other).
As a safety feature, this plug will fit in a polarized outlet only one way. If the plug
does not fit fully in outlet, reverse the plug. If it still does not fit, contact a quali-
fied electrician. Do not attempt to defeat this safety feature.
1. If using a cartridge for the first time, remove roller applicator cap and shipping
stopper. Then reattach the roller applicator for use.
NOTE: Make sure the stopper is removed for product to work properly.
2. Wash the area to be waxed with mild soap and water, and dry skin thoroughly.
3. Do not apply hot wax near eyes or other heat sensitive areas such as skin injury,
eruption or surface growth.
4. Before use, make sure that the stopper has been removed from the cartridge and
applicator is tightly secured.
5. Place the wax cartridge into the heating chamber.
6. Plug the power cord into the device and then into the socket.
n The charging light will illuminate to confirm the device is heating. After 20
minutes the wax is ready for application.
n Unplug the device and start by applying the wax to a small area first to check
that the wax applies easliy and is not too hot.
n If the wax does not easily roll onto the skin, let the device warm the wax for
an additional 5 minutes. Unplug before beginning treatment.
7. Apply a thin layer of wax in the direction of hair growth. Make sure the roller
head is in contact with the skin to allow the roller to glide over the skin.
8. Immediately place a strip over the layer of wax, ensuring that there is at least
1cm at the bottom that is wax free. Rub the strip repeatedly over the wax in the
direction of hair growth.
9. Hold your skin taut to avoid discomfort. Holding the bottom of the strip, very
quickly and in one swift motion, pull the strip back on itself against the direction
of hair growth. The faster you move the strip the more effective it will be.
NOTE: Wax is not supposed to harden. Immediately remove cloth strip.
10.When you have finished waxing remove any residue with lukewarm water and a
clean cloth.
Underarms: Test a small area first, since the underarm area is sensitive. If
you are perspiring, be sure to use powder prior to wax use. Spread wax in the
direction of hair growth. Apply the cloth strip over the wax and remove the cloth
strip in the opposite direction. Underarm hair removal should be done in two